How do I unclog a conductive pen?
If you experience difficulty in producing a smooth flow of conductive ink, this could indicate clogging of the product outflow channel within the tip assembly. As the pen sits in storage, especially if stored tip downward, the suspended silver...
Read This Post
Conductive Pen Tips and Tricks for Best Performance
CircuitWorks Conductive Pens have a wide range of uses, from drawing traces between components on prototype circuit boards, coating components and assemblies to shield them from electrical and radio frequency interference, to repairing broken...
Read This Post
How do you apply liquid conformal coating? (CTSR-X, CTLED)
Apply to clean, moisture-free surface. Areas not requiring coating should be masked. Application: Coating may be applied by spraying, brushing, dipping or flow coating. Allow coating to flow around components. Cure: Room temperature cure:...
Read This Post
How do you apply liquid conformal coating? (CTSR)
Apply to clean, moisture-free surface. Areas not requiring coating should be masked. Application: Coating may be applied by spraying, brushing, dipping or flow coating. Allow coating to flow around components. Cure: Room temperature cure:...
Read This Post
How do you use an aerosol conformal coating? (CTSR-12)
Shake well. SURFACE MUST BE CLEAN & MOISTURE FREE. Areas not requiring coating should be masked. Coating: Spray top to bottom, allowing coating to flow around components. Rotate board 90˚ and repeat process 2 or more times. If nozzle clogs,...
Read This Post
How do you apply liquid conformal coating? (CTAR)
Apply to clean, moisture-free surface. Areas not requiring coating should be masked. Application: Coating may be applied by spraying, brushing, dipping or flow coating. Allow coating to flow around components. Cure: Room temperature cure:...
Read This Post
How do you use an aerosol conformal coating? (CTAR-12)
Shake well. SURFACE MUST BE CLEAN & MOISTURE FREE. Areas not requiring coating should be masked. Coating: Spray top to bottom, allowing coating to flow around components. Rotate board 90˚ and repeat process 2 or more times. If nozzle clogs,...
Read This Post
How do you use freeze spray?
For failure isolation, energize the suspect PC board. Spray on board to determine the area where the failure is occurring. Attach extension tube and spray on individual components until the failed component has been isolated.
Read This Post
How do you use an aerosol cleaner?
Hold object to be cleaned in vertical position. Pull trigger gently to control solvent flow rate. Scrub with brush from top to bottom, allowing the liquid to flush away contaminants.
Read This Post
Cleanroom Compatibility of Chemtronics Duster, ESD Products & Aerosols
From time to time, we receive inquiries in Technical Support asking if a particular Chemtronics product is cleanroom grade or cleanroom compatible. Usually this question arises with regard to our duster products, but may also involves our static...
Read This Post
